|
Last Modified: 11-29-2007 |
1.6 A |
|
Service Category: Vehicle Interior |
Section: Seat |
|
Model Year: 2008 |
Model: Sequoia |
Doc ID: RM0000030LD002X |
|
Title: SEAT: LUMBAR SUPPORT ADJUSTER ASSEMBLY (for Power Seat): REMOVAL (2008 Sequoia) |
REMOVAL
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
-
Use the same procedure for the LH side and RH side.
-
The procedure listed below is for the LH side.
1. REMOVE FRONT SEAT ASSEMBLY LH
(a) Remove the front seat
.
2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH
3. REMOVE RECLINING POWER SEAT SWITCH KNOB
4. REMOVE FRONT SEAT CUSHION SHIELD LH
5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
6. REMOVE FRONT SEAT CUSHION SHIELD INNER LH
7. REMOVE FRONT SEAT HEADREST SUPPORT
8. REMOVE SEATBACK COVER WITH PAD
9. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (w/ Climate Control Seat System)
|
(a) Disconnect the connector and disengage the 2 clamps.
|
|
(b) Remove the 4 springs.
|
(c) Disengage the 4 hooks and remove the seatback spring.
|
(d) Disconnect the connector.
|
(e) Remove the 2 screws and lumbar support adjuster assembly.
|
(f) Disengage the 3 claws and remove the bush from the seat frame.
|
10. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (w/o Climate Control Seat System)
|
(a) Remove the 2 springs.
|
(b) Detach the 6 hooks and remove the seatback spring.
|
(c) Disconnect the connector.
|
(d) Remove the 2 screws and lumbar support adjuster assembly.
|
(e) Disengage the 3 claws and remove the bush from the seat frame.
|
|